IBM 8863 User Manual - Page 34
Installation
![]() |
UPC - 000435474667
View all IBM 8863 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
1. Read the safety information beginning on page v and "Installation guidelines" on page 7. 2. Remove the server cover and determine which PCI-X expansion slot you will use for the adapter. PCI-X retaining bar PCI-X divider Attention Tab LED (yellow) Power LED (green) Adapter retention latch DCAC 3. See the documentation that comes with the adapter for instructions on setting jumpers or switches and for cabling. Note: Route adapter cables before you install the adapter. 4. Install the adapter: a. Open the blue adapter guide by lifting the front edge. b. Push the orange adapter retention latch toward the rear of the server and open the tab. The power LED for the slot turns off. c. Remove the expansion-slot cover. d. Carefully grasp the adapter by its top edge or upper corners, and align it with the connector on the PCI-X board. e. If necessary, remove the adapter guide before installing a full-length adapter. f. Press the adapter firmly into the adapter connector. g. Push down on the blue PCI-X retaining bar to stabilize the adapter. h. Close the tab; then, push down on the orange adapter retention latch until it clicks into place, securing the adapter. 5. Connect any required cables to the adapter. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 23. 22 IBM xSeries 366 Type 8863: Installation Guide
![](/manual_guide/products/ibm-88632ru-user-manual-05f8a35/34.png)