IBM 9494HB0 User Guide - Page 12

AutoSetup for Windows 3.1, Windows 95, Windows 98, Windows 2000, Windows Me, Windows XP or Windows NT i If the monitor is in standby mode (STANDBY ON), it 1. may automatically turn off while you are waiting for it to warm up. Turn on the monitor first; then the computer. If the message CHECK VIDEO CABLE is displayed, or if nothing is displayed, check: • that the video interface cable is not connected properly. • the correct video adapter card is not installed. 2. Wait approximately 15 minutes, until the monitor warms up. 3. Ensure that the icon bar and tool bar, if displayed are at the bottom of the screen. 4. Insert the CD labelled 'IBM Monitor CD' into the CD drive. 5. Check the operating system installed on your computer and follow the i The size and diversity of the dot pattern varies with the instructions from the table below. screen resolution. Operating System Step1 Step2 Step3 Windows 3.1 Windows 95 Windows 98 Windows 2000 Windows Me Windows XP Open PROGRAM Manager Select START Select RUN Select RUN Type 'P:\TESTPAT' and press ENTER Microsoft Windows NT®4.0 6. When the test pattern appears, press the OSD Enter button at the bottom of the monitor to display the initial OSD menu. i Position the mouse pointer at the bottom center of the screen. This allows AUTO SETUP to run properly 7. Use an Arrow button ( or ), to select the IMAGE SET-UP icon and press the OSD Enter button to access the function. 8. Using an Arrow button ( or ), select AUTO and press the OSD Enter button . This activates the AUTO SETUP procedure, which will optimize the display settings with the provided test pattern. The image may be affected during this procedure and you may notice small changes to the test pattern. To abort the AUTO SETUP function, press the ESC key. 9. When finished, the OSD main menu returns. Press the Exit button once to exit from the OSD. 10