IBM 9494HB0 User Guide - Page 7
Switching on your Monitor, Auto Setup
 |
UPC - 087944714866
View all IBM 9494HB0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ENGLISH 3. Connect the power cord to the power adapter and then plug the power cord into a properly grounded outlet. Next, reconnect the power cord(s) to your computer and all attached devices. Switching on your Monitor 1. Switch on the adapter power source by pushing the power switch A on the top rear panel of the monitor. 2. Switch on your monitor by pushing and releasing the power switch marked [ ] at the front of the bezel. [To switch off your monitor, push and release the power switch again.] 3. Switch on your computer. 4. If you are using the analog connector, run AUTO SETUP by following the instructions in the Auto Setup section on page 9. 5
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
ENGLISH
5
1.
Switch on the adapter power source by pushing the power switch
on the top
rear panel of the monitor.
2.
Switch on your monitor by pushing and releasing the power switch marked [
]
at the front of the bezel.
[To switch off your monitor, push and release the power switch again.]
3.
Switch on your computer.
4.
If you are using the analog connector, run AUTO SETUP by following the
instructions in the
Auto Setup
section on page 9.
Switching on your Monitor
A
3.
Connect the power cord to the power adapter and then plug the power cord
into a properly grounded outlet. Next, reconnect the power cord(s) to your
computer and all attached devices.