IBM 9494HB0 User Guide - Page 22

Further Information Display modes i If your computer has previously been used with a CRT monitor and is currently configured to a display mode outside the range that the Flat Panel monitor can display, you may need to re-attach the CRT monitor temporarily until you have reconfigured the computer, preferably to 1280 x 1024 at 60Hz. The display mode the monitor uses is controlled by the computer. Therefore, you should refer to your computer documentation for details on how to change display modes. The image size, position and shape may change when the display mode changes. This is normal and the image can be readjusted using AUTO SETUP and the monitor controls. Unlike CRT monitors, which require a high refresh rate to minimize flicker, TFT technology is inherently flicker-free. If possible, configure your computer for 1280 x 1024 addressability at 60Hz vertical refresh rate. For the display modes listed below, the screen image has been optimized during manufacture. Factory Set Display Modes Addressabillty Refresh Rate Horizontal Frequency Note : VESA timings are as detailed in the VESA "Display Monitor Timing Specification". Version 1.0, Revision 0.8, Dated 09/17/98. 640 x 480 640 x 480 640 x 480 640 x 350 720 x 400 800 x 600 800 x 600 800 x 600 832 x 624 1024 x 768 1024 x 768 1024 x 768 1152 x 870 1152 x 900 1280 x 1024† 1280 x 1024 † Recommended 60 Hz 75 Hz 85 Hz 70 Hz 70 Hz 60 Hz 75 Hz 85 Hz 75 Hz 60 Hz 75 Hz 85 Hz 75 Hz 65 Hz 60 Hz 75 Hz 31.5 kHz 37.5 kHz 43.3 kHz 31.5 kHz 31.5 kHz 37.9 kHz 46.9 kHz 53.7 kHz 49.7 kHz 48.4 kHz 60.0 kHz 68.7 kHz 68.7 kHz 61.8 kHz 63.98 kHz 79.98 kHz 20