IBM 9512AB1 User Guide - Page 23

Problem, Possible, Cause, Suggested, Action, Reference

Page 23 highlights

ENGLISH Problem Possible Cause Suggested Action Reference Screen is blank Display mode of and power the computer is indicator is outside the flashing green range of the every 0.5 monitor second • Reconfigure key on the computer to use a supported display mode. Further Information section on page 18. CHECK VIDEO The monitor is CABLE not receving a message is video signal shown and power indicator is steady amber. • Check that the signal cabel is firmly connected to the computer. • Check that no pins are bent in the signal cable connector. Connecting your monitor section on page 3. Image appears to be smeared There are noises • Select IMAGE SET-UP menu in the video in the OSD. Then select signal MANUAL to adjust FINE / COARSE settings. User Controls section on page 14. i For image problems, you may want to run AUTO SETUP again before consulting to this section. In most cases, AUTO SETUP can fix the problems. See Auto Setup for the computer on page 8 for details. Image appears The color setting • Adjust the Color settings. to be discolored may be incorrect. User Controls section on page 14. A few dots are missing, discolored, or inappropriately lighted. The LCD contains over 2,300,000 thin-film transistors (TFTs). A small number of missing, discolored, or lighted dots may be present on the screen, which is an intrinsic characteristic of the TFT LCD technology and is not an LCD defect. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25

ENGLISH
21
i
For image problems, you
may want to run
A
UTO
S
ETUP again before
consulting to this section. In
most cases,
A
UTO SETUP
can fix the problems. See
Auto Setup for the computer
on page
8
for details.
Problem
Possible
Cause
Suggested
Action
Reference
There are noises
in the video
signal
The color setting
may be incorrect.
The LCD contains over 2,300,000 thin-film transistors (TFTs).
A small number of missing, discolored, or lighted dots may be
present on the screen, which is an intrinsic characteristic of the
TFT LCD technology and is not an LCD defect.
Screen is blank
and power
indicator is
flashing green
every 0.5
second
CHECK
VIDEO
CABLE
message is
shown and
power indicator
is steady amber.
Image appears
to be smeared
Image appears
to be discolored
A few dots are
missing,
discolored, or
inappropriately
lighted.
User
Controls
section on
page
14
.
User
Controls
section on
page
14
.
Select IMAGE SET-UP menu
in the OSD. Then select
MANUAL to adjust FINE /
COARSE settings.
Adjust the Color settings.
Connecting
your monitor
section on
page
3
.
Check that the signal cabel
is firmly connected to the
computer.
Check that no pins are bent
in the signal cable connector.
The monitor is
not receving a
video signal
Display mode of
the
computer
is
outside the
range of the
monitor
Reconfigure key on the
computer to use
a supported
display mode.
Further
Information
section on
page
18.