IBM 9512AB1 User Guide - Page 6

Switching on your Monitor

Page 6 highlights

3. Connect the power cord to the monitor and then plug the power cord into a properly grounded outlet. Next, reconnect the power cord(s) to your computer and all attached devices. Switching on your Monitor 1. Switch on your monitor by pushing and releasing the power switch marked [ ] at the front of the bezel. [To switch off your monitor, push and release the power switch again.] 2. Switch on your computer. 3. If you are using the analog connector, run AUTO SETUP by following the instructions in the Auto Setup section on page 8. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25

4
1.
Switch on your monitor by pushing and releasing the power switch marked [
]
at the front of the bezel.
[To switch off your monitor, push and release the power switch again.]
2.
Switch on your computer.
3.
If you are using the analog connector, run AUTO SETUP by following the
instructions in the
Auto Setup
section on page
8
.
Switching on your Monitor
3.
Connect the power cord to the
monitor
and then plug the power cord into a
properly grounded outlet. Next, reconnect the power cord(s) to your computer
and all attached devices.