IBM x3800 User Guide - Page 89
Using, SAS/SATA, Configuration, Utility, program, Starting, SerialSelect, choices, Utilities,
UPC - 000435948984
View all IBM x3800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
- reboot Force the server to restart. - sel get Display the BMC system event log. - sol Configure the SOL function. - sysinfo Display system information that is related to the server and the globally unique identifier (GUID). Using the SAS/SATA Configuration Utility program Use the SAS/SATA Configuration Utility program to configure SAS devices. Starting the SAS/SATA Configuration Utility program To start the SAS/SATA Configuration Utility program, complete the following steps: 1. Turn on the server. 2. When the prompt > appears, press Ctrl+A. 3. To select a choice from the menu, use the arrow keys. 4. Follow the instructions on the screen to change the SerialSelect Utility or Disk Utilities settings. SerialSelect Utility menu choices The following choices are on the SerialSelect Utility menu: v SAS Controller Configuration Select this choice to view or change SAS controller settings. To reset the controller to its default settings, press F6 and follow the instructions on the screen. v PHY Configuration Select this choice to view or change the physical layer (PHY) configuration settings. To reset the controller to its default settings, press F6 and follow the instructions on the screen. Disk Utilities Select this choice to format, verify, or locate SAS devices. Select a device from the list and read the instructions on the screen carefully before making a selection. Using ServeRAID Manager Use ServeRAID Manager, which is on the IBM ServeRAID Support CD, to: v Configure a redundant array of independent disks (RAID) array v Restore a SCSI hard disk drive to the factory-default settings, erasing all data from the disk v View the RAID configuration and associated devices v Monitor the operation of the RAID controllers To perform some tasks, you can run ServeRAID Manager as an installed program. However, to perform an initial RAID configuration on the server, you must run ServeRAID Manager in Startable CD mode, as described in the instructions in this Chapter 3. Configuring the server 77