Icom IC-7300 Instruction Manual basic - Page 56
Function
View all Icom IC-7300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
8 SET MODE Function Beep Level (Default: 50%) Sets the beep output level. LIf the "Beep (Confirmation)" item is set to "OFF," no beep sounds. Beep Level Limit (Default: ON) Selects whether or not to limit the volume up to the specified level. Time-Out Timer (CI-V) (Default: OFF) Sets the Time-out Timer for CI-V operation. This setting is valid only transmitting initiated by a CI-V command or pushing TRANSMIT . LSelect "OFF" for no time limit. Quick SPLIT (Default: ON) Turns the Quick Split function ON or OFF. Beep (Confirmation) (Default: ON) Turns the Confirmation beep ON or OFF. LIf the "Beep Level" item is set to "0%," no beep sounds. Band Edge Beep (Default: ON (Default)) Turns the Band Edge beep ON or OFF. LLInformatio ••If the "Beep Level" item is set to "0%," no beep sounds. ••When you tune into an amateur band's frequency range, the Band Edge high beep sounds. ••When you tune out of an amateur band's frequency range, the Band Edge low beep sounds. RF/SQL Control (Default: RF+SQL) Set the AF RF/SQL (outer) control operation. MF Band ATT (Default: ON) Turns the MF Band Attenuator function ON or OFF. This function adds approximately 16 dB of attenuation to prevent a desired signal from becoming distorted when very strong MF band signals are received. This function is usable when the frequency is set to between 0.03000 and 1.59999 MHz, for only receiving. LWhen you receive a weak signal on the MF band, select "OFF." LThe 16 dB of the MF band attenuation is added to any other attenuation value that you have set. TX Delay HF (Default: OFF) FM SPLIT Offset (HF) (Default: -0.100 MHz) FM SPLIT Offset (50M) (Default: -0.500 MHz) Sets the frequency offset for the Split function in the FM mode on the HF or 50 MHz band. SPLIT LOCK (Default: OFF) Turns the Split Lock function ON or OFF. [TUNER] Switch (Default: Auto) Selects whether or not to save the internal antenna tuner's status after pushing TUNER on each band. PTT Start (Default: OFF) Turns the PTT Start Tuning function ON or OFF. Clears the all of the internal antenna tuner preset points. RTTY Mark Frequency (Default: 2125) Selects the RTTY mark frequency. LWhen the internal RTTY decoder is used, 2125 Hz is automatically selected. RTTY Shift Width (Default: 170) Selects the RTTY shift width. LWhen the internal RTTY decoder is used, 170 Hz is automatically selected. TX Delay 50M (Default: OFF) RTTY Keying Polarity Selects the RTTY keying polarity. TX Delay 70M* (Default: OFF) Sets the TX delay time on the HF, 50 or 70 MHz band. LIf an external equipment's rise time is slower than that of the IC-7300, a reflected wave is produced and it may damage the IC-7300. To prevent this, set the appropriate delay time so that no reflected wave is produced. LSelect "OFF" for no rise speed. *Depending on the transceiver's version, this item may not be displayed. SPEECH Language Selects the speech language. SPEECH Speed Selects the speech speed. 8-3 (Default: Normal) (Default: English) (Default: Fast)