Icom IC-F5061D Instruction Manual - Page 24

Safety Training Information

Page 24 highlights

4 SAFETY TRAINING INFORMATION Your Icom radio generates RF electromagnetic en- 3. IC-F5061/IC-F5061D: ergy during transmit mode. This radio is designed Transmit only when people outside the vehicle are at least the for and classified as "Occupational Use Only", recommended minimum distance of 100 centimeters away from meaning it must be used only during the course of the properly installed antenna. This separation distance will en- W ARN ING employment by individuals aware of the hazards, and the ways to minimize such hazards. This radio sure that there is sufficient distance from a properly installed externally-mounted antenna to satisfy the RF exposure require- is NOT intended for use by the "General Popula- ments in the applicable RF exposure compliance standards. tion" in an uncontrolled environment. 3. IC-F6061/IC-F6061D: Transmit only when people outside the vehicle are at least the • For compliance with FCC and IC RF Exposure Requirements, the recommended minimum distance of 82 centimeters away from transmitter antenna installation shall comply with the following three the properly installed antenna. This separation distance will en- conditions: sure that there is sufficient distance from a properly installed 1. The transmitter antenna gain shall not exceed 0 dBi. externally-mounted antenna to satisfy the RF exposure require- 2. IC-F5061/IC-F5061D: ments in the applicable RF exposure compliance standards. The antenna is required to be located outside of a vehicle and kept at a distance of 45 centimeters or more between the trans- mitting antenna of this device and any persons during operation. For small vehicle as worst case, the antenna shall be located on the roof top at any place on the centre line along the vehicle in order to achieve 45 centimeters separation distance. In order to ensure this distance is met, the installation of the antenna must be mounted at least 45 centimeters away from the nearest edge of the vehicle in order to protect against exposure to bystanders. 2. IC-F6061/IC-F6061D: The antenna is required to be located outside of a vehicle and kept at a distance of 37 centimeters or more between the trans- mitting antenna of this device and any persons during operation. For small vehicle as worst case, the antenna shall be located on the roof top at any place on the centre line along the vehicle in order to achieve 37 centimeters separation distance. In order to ensure this distance is met, the installation of the antenna must be mounted at least 37 centimeters away from the nearest edge of the vehicle in order to protect against exposure to bystanders. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

WARNING
Your Icom radio generates RF electromagnetic en-
ergy during transmit mode. This radio is designed
for and classified as “Occupational Use Only”,
meaning it must be used only during the course of
employment by individuals aware of the hazards,
and the ways to minimize such hazards. This radio
is NOT intended for use by the “General Popula-
tion” in an uncontrolled environment.
• For compliance with FCC and IC RF Exposure Requirements, the
transmitter antenna installation shall comply with the following three
conditions:
1. The transmitter antenna gain shall not exceed 0 dBi.
2. IC-F5061/IC-F5061D:
The antenna is required to be located outside of a vehicle and
kept at a distance of 45 centimeters or more between the trans-
mitting antenna of this device and any persons during operation.
For small vehicle as worst case, the antenna shall be located on
the roof top at any place on the centre line along the vehicle in
order to achieve 45 centimeters separation distance. In order to
ensure this distance is met, the installation of the antenna must
be mounted at least 45 centimeters away from the nearest edge
of the vehicle in order to protect against exposure to bystanders.
2. IC-F6061/IC-F6061D:
The antenna is required to be located outside of a vehicle and
kept at a distance of 37 centimeters or more between the trans-
mitting antenna of this device and any persons during operation.
For small vehicle as worst case, the antenna shall be located on
the roof top at any place on the centre line along the vehicle in
order to achieve 37 centimeters separation distance. In order to
ensure this distance is met, the installation of the antenna must
be mounted at least 37 centimeters away from the nearest edge
of the vehicle in order to protect against exposure to bystanders.
3. IC-F5061/IC-F5061D:
Transmit only when people outside the vehicle are at least the
recommended minimum distance of 100 centimeters away from
the properly installed antenna. This separation distance will en-
sure that there is sufficient distance from a properly installed
externally-mounted antenna to satisfy the RF exposure require-
ments in the applicable RF exposure compliance standards.
3. IC-F6061/IC-F6061D:
Transmit only when people outside the vehicle are at least the
recommended minimum distance of 82 centimeters away from
the properly installed antenna. This separation distance will en-
sure that there is sufficient distance from a properly installed
externally-mounted antenna to satisfy the RF exposure require-
ments in the applicable RF exposure compliance standards.
19
4
SAFETY TRAINING INFORMATION