Icom IC-F70 / F80 Instruction Manual - Page 25
Transmitting a call
View all Icom IC-F70 / F80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
BIIS OPERATION 4 I Transmitting a call A total of 3 ways for code selection are available-selecting the call code from memory, entering the call code from the D Calling back from the queue channel q While in the standby condition, push and hold [P1] (Digital) keypad and calling back from the queue channel record. for 1 sec. to enter the queue memory channel selection mode. 4 D Using call memory w Push [Up] or [Down] to select the desired record. q While in the standby condition, push [P1] (Digital) to enter the call code memory channel selection mode. • " " appears. Appears X X w Push [Up] or [Down] to select the desired call code. e Push [P0] (Call) or [PTT]* to call. *PTT call can be made only when PTT call capability is permitted. NOTE: When no answer back is received, the transceiver repeats the call 3 times (default) automatically, and "WAIT" is displayed during each call. However, an error beep sounds and "FAILED" is displayed when no answer back is received after the calls. r Push [PTT] to transmit; release to receive. t Push [P4] (Moni(Audi)) to send the 'Clear down' signal. e Push [P0] (Call) or [PTT]* to call. *PTT call can be made only when PTT call capability is permitted. NOTE: When no answer back is received, the transceiver repeats the call 3 times (default) automatically, and "WAIT" is displayed during each call. However, an error beep sounds and "FAILED" is displayed when no answer back is received after the calls. r Push [PTT] to transmit; release to receive. t Push [P4] (Moni(Audi)) to send the 'Clear down' signal. 21