Icom IC-F70 / F80 Instruction Manual - Page 31
Position data transmission
View all Icom IC-F70 / F80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
BIIS OPERATION 4 I Position data transmission • Available characters Key Characters [0] When the optional cable (OPC-966) and a GPS receiver is connected to the transceiver, the position (longitude and lati- tude) data can be transmitted automatically. Ask your dealer or system operator for connection details. 4 [1] [2] [3] [4] [5] [6] [7] [8] [9] NOTE: A decimal point can only be written with the CSF70/F1700 CLONING SOFTWARE. Pre-programmed characters can be rewritten with the 10-keypad, except for the decimal point, as it is not included in the transceiver character list, and cannot be displayed again. The position data is transmitted when; • Status 24 message is received *When the status 24 message, GPS request, is received. • Fully automatic When automatic position transmission is enabled, send the position data according to 'Time Marker' and 'Interval Timer' settings. • PTT is released When 'Send with Logoff' is enabled. - Set the 'Log-In/Off' item as 'L-OFF.' • After sending a status message When 'Send with Status' is enabled. • After sending an SDM When 'Send with SDM' is enabled. • After sending status 22 (Emergency) When 'Send with Emergency' is enabled. 27