Icom IC-F70 / F80 Instruction Manual - Page 26
Direct code entry
View all Icom IC-F70 / F80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
4 BIIS OPERATION D Direct code entry q While in the standby condition, push [P3] (TX Code Enter) to enter the TX code edit mode. • Code digit for editing blinks. u Push [PTT] to transmit; release to receive. i Push [P4] (Moni(Audi)) to send the 'Clear down' signal. For your information When the "UpDate" setting for the call code is enabled, the set code is overwritten into the call code memory. X w Push [P3] (TX Code Enter) to select the desired digit to be edited. • Digit for editing differs according to the setting. e Set the desired digit using [CH Up]/[CH Down] or 10-keypad*. *IC-F70DT/T or IC-F80DT/T only r Push [P3] (TX Code Enter) to set the digit, then the digit to the right will blink automatically. • When the 10-keypad is used for setting, the digit to the right will blink automatically without pushing [P3] (TX Code Enter). t Repeat e and r to input all allowable digits. y Push [P0] (Call) or [PTT]* to call. *PTT call can be made only when PTT call capability is permitted. NOTE: When no answer back is received, the transceiver repeats the call 3 times (default) automatically, and "WAIT" is displayed during each call. However, an error beep sounds and "FAILED" is displayed when no answer back is received after the calls. 22