Icom IC-M36 Service Manual - Page 18
Disassembly Instruction, Removing Front Panel, Removing Main Unit, Removing Chassis
View all Icom IC-M36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
SECTION 3. DISASSEMBLY INSTRUCTION 1. REMOVING FRONT PANEL • Unscrew 4 screws from the rear panel, and remove the rear panel from the front panel. NOTICE: NOT to lost 2 o-rings. Screw O-ring Screw 3. REMOVING MAIN UNIT 1) Unsolder 2 points from the top side, and 1 point from the bottom side. Unsolder Unsolder REAR PANEL TOP SIDE BOTTOM SIDE 2) Unscrew 4 screws from the MAIN UNIT. 3) Disconnect the microphone cable from the MAIN UNIT. 4) Take off the MAIN UNIT from the chassis. Screw x4 FRONT PANEL MICROPHONE CABLE 2. REMOVING CHASSIS 1) Unsolder 2 points from the speaker. 2) Unscrew ANT nut from the antenna connector, and 5 screws from the MAIN UNIT. 3) Take off the chassis with MAIN UNIT from the front panel in the direction of the arrow. Screw (long) ANT CONNECTOR ANT NUT Screw (short) x3 CHASSIS MAIN UNIT TOP S TO MAIN UNIT Unsolder 3 - 1