Icom IC-R8600 I/q Output Reference Guide - Page 11

I/Q SIGNAL ■■Control commands relative to I/Q port setting DDReceive frequency Command: 05 q XX w XX e XX r XX t XX 10Hz d ig it : 0 ~ 9 1Hz d ig it : 0 ~ 9 1kHz d ig it : 0 ~ 9 100Hz d ig it : 0 ~ 9 100kHz d ig it : 0 ~ 9 10kHz d ig it : 0 ~ 9 10MHz d ig it : 0 ~ 9 1MHz d ig it : 0 ~ 9 1GHz d ig it : 0 ~ 3 100MHz d ig it : 0 ~ 9 LYou can omit the upper digits entry. When omitted, the current frequency is applied. DDReceive Band edge frequency Command: 1A 0F PC to IC-R8600 (Write data format) Specify the band edge to read by the edge number in a BCD code. q XX Edge number: 01 to XX* LThe upper number (*marked) will be the returned value of command "1A 0E." LIf the specified number exceeds the readable capacity, "NG (FA)" will be returned. To read the number of the edge, send command "1A 0E" (The Read Receive Band Edge Count command). IC-R8600 to PC (Read data format) q w e r t y u i o !0 !1 !2 XX XXXXXXXXXX 2 DXXXXXXXXXX Edge number 01~XX* 10 Hz digit: 0 ~ 9 1 Hz digit: 0 ~ 9 1 kHz digit: 0 ~ 9 100 Hz digit: 0 ~ 9 100 kHz digit: 0 ~ 9 10 kHz digit: 0 ~ 9 10 MHz digit: 0 ~ 9 1 MHz digit: 0 ~ 9 1 GHz digit: 0 ~ 3 100 MHz digit: 0 ~ 9 Separator (Fixed) 10 Hz digit: 0 ~ 9 1 Hz digit: 0 ~ 9 1 kHz digit: 0 ~ 9 100 Hz digit: 0 ~ 9 100 kHz digit: 0 ~ 9 10 kHz digit: 0 ~ 9 10 MHz digit: 0 ~ 9 1 MHz digit: 0 ~ 9 1 GHz digit: 0 ~ 3 100 MHz digit: 0 ~ 9 Edge frequency (Lower) Edge frequency (Upper) LThe upper number (*marked) will be the returned value of command "1A 0E." LThe lower edge frequency, separator (fixed to "2D") and upper edge frequency are returned as well as the Edge number. 10