Icom IC-R8600 I/q Output Reference Guide - Page 14

I/Q SIGNAL ■■Operations while the IC-R8600 is in the I/Q mode You need to enter the I/Q mode to get I/Q signals. While the IC-R8600 is in the I/Q mode, [REMOTE] LED lights and the IC-R8600 is in the "Remote controlled mode," thus you cannot operate the IC-R8600. To exit the I/Q mode, send the command that cancels the mode, or push the [LOCAL] key on the IC-R8600 front panel. Turning OFF the IC-R8600's power also exits the I/Q mode. While the IC-R8600 is in the I/Q mode, the operations that a user can perform are limited. DDOperation limitations in the I/Q mode Setting: All changes (frequency, preamp setting, and so on) made in the I/Q mode are not saved. All the settings will be returned to the condition/state before entering the I/Q mode. Receive setting: While in the I/Q mode, the receive mode is fixed to "USB," and "AGC" is forcibly turned OFF. Audio output: Audio output from the internal speaker, external speaker terminal and headphone terminal are muted. The audio output from the USB Audio, [AF/IF] terminal and [LAN] port are not muted. The Monitor function is forcibly turned OFF. Others: • Normal scan, Priority scan and Tone scan are not usable. (Forcibly canceled if running.) • The Recording function is not usable. • The Memory channel is not automatically changed by the Timer function. (The Automatic Power OFF function is still usable.) • The BER measurement function is not usable, and forcibly turned OFF if in use. • "NG (FA)" will be returned to all the commands excepts those related to the I/Q mode: reading and entering the I/Q mode. Setting receive frequency, receive mode transceive and receiving digital signals are disabled. • The cloning operation using the CS-R8600 is not usable. • The IF signal from the 10.7 MHz OUT is disabled. 13