Icom IC-T10 Advanced Manual - Page 12

2 MEMORY OPERATION Entering a memory name Each memory channel can be given a name of up to 6 characters. Step 1. Selecting a display mode Select "nAmE" in the Display Mode item in the Initial Set mode, to display the channel name. 1. Rotate [VOL] counter-clockwise to turn OFF the transceiver. 2. While holding down [SET], rotate [VOL] clockwise to turn ON the transceiver. ••An Initial Set mode item is displayed. 3. Repeatedly push [SET] until "dISP m" is displayed. LLYou can also select by pushing [MONI] or [P]. Step 2. Entering a memory name 1. Push [S.MW] until two short beeps sound. ••" " and the channel number blink. 2. Rotate [DIAL] to Select a Memory Channel to enter a name. 4. Rotate [DIAL] to select "nAmE." 3. Push [SET]. ••"nAmE" is displayed. 5. Push [V/M/C] or [ENT] to exit the Initial Set mode. 6. Repeatedly push [V/M/C] to select the Memory mode. 4. Hold down [SET] until two beeps sound. ••The first digit blinks, and the transceiver enters the Name Entry mode. 7. Rotate [DIAL] to select the channel that a memory name is given. LLA frequency is displayed for the channel without channel name. 5. Rotate [DIAL] to enter the first digit. LLPush [MONI] to move the cursor to the right. LLPush [P] to move the cursor to the left. Usable characters: [A] [b] [C] [d] [E] [F] [G] [H] [ I ] [J] [k] [L] [m] [n] [O] [P] [q] [R] [S] [ t ] [U] [V] [W] [X] [y] [Z] [1] [2] [3] [4] [5] [6] [7] [8] [9] [0 Space ] 6. Repeat Step 5 to enter the rest of the digits. 7. Push [S.MW] to apply the entry. ••"nAmE" is displayed. 8. Push [S.MW and the channel number blink. LLRepeat Step 2 to 8 to re-enter a memory name. 9. Push [S.MW] to return to the Memory mode. 2-5