Icom IC-T10 Advanced Manual - Page 24
Using Set Mode, Using the Basic Set mode
![]() |
View all Icom IC-T10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
5 SET MODE Using Set Mode You can use the Set mode to set infrequently changed values or function settings. The transceiver has two types of Set modes, as shown below. DDUsing the Basic Set mode Example: Selecting a 20 kHz tuning step 1. Push [SET] to enter the Set mode. ••A Set mode item is displayed. 2. Push [SET] several times to select "tS." LLAlternatively, you can also push [MONI] or [P] to select "tS" 3. Rotate [DIAL] to select "20.0." 4. Push [V/M/C] or [ENT] to exit the Set mode. DDUsing the Initial Set mode Example: Setting the Auto Power OFF Timer to 30 minutes 1. Rotate [VOL] counter-clockwise to turn OFF the transceiver. 2. While holding down [SET], rotate [VOL] clockwise to turn ON the transceiver. ••An Initial Set mode item is displayed. 3. Push [SET] several times to select "AP OFF." 4. Rotate [DIAL] to select "30." 5. Push [V/M/C] or [ENT] to exit the Initial Set mode. 5-2
![](/manual_guide/products/icom-ict10-advanced-manual-7bf3754/24.png)