Image Fitness 4.0smith Machinekit English Manual - Page 9

11. Lay a Weight Upright (42) on the floor. Slide a 11 Weight Carriage (37) into the Weight Upright. Be sure that the Weight Carriage is oriented as shown. Slide the Weight Upright (42) onto the M10 x 80mm Carriage Bolts (8) in the Left Base (25). 42 Be sure that the Weight Upright is turned so that the slot is on the side shown. Thread an M10 Nylon Locknut (1) onto each M10 x 80mm Carriage Bolt. Do not tighten the Nylon Locknuts yet. Slot Assemble the other Weight Upright (42) in the same manner. 37 37 26 25 8 12. Attach the Left Barbell Upright (41) to the bracket on the Left Base (25) with an M10 x 65mm Bolt (7) and an M10 Nylon Locknut (1). Attach the Right Barbell Upright (38) to the bracket on the Right Base (26) with an M10 x 65mm Bolt (7) and an M-10 Nylon Locknut (1). Insert a Safety Stop (23) into each Barbell Upright (38, 41). Slide four Roller Bushings (30) onto each Barbell Rack (31). Slide a Barbell Rack into each Barbell Upright (38, 41). The Roller Bushings must be turned as shown in the Inset drawing. Be sure that the Barbell Racks are oriented as shown. Attach a Storage Tube (68) to the Right Base (26) with an M8 x 65mm Bolt (72), two M8 Washers (70), two 11mm x 13mm Spacers (69), and an M8 Nylon Locknut (71). Press a 1" Round Inner Cap (12) into the Storage Tube. Attach the other Storage Tube (68) to the Left Base (25) in the same manner. 12 31 30 /\ A 30 30 30 38 41 23 23 68 7 Bracket 25 12 68 71 70 7 0 0 Bracket 26 69 72 Beveled edge must face this"----a" direction 31 9