Image Fitness Access 3000 English Manual - Page 18
Icatvpable,conne
View all Image Fitness Access 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
ANTENNA' CONNECTIONS: Indoor Antenna 1. Place the VHF antenna in the desired location. Connect the 300 ohm flat wire to the screws on the 300 ohm to 75 ohm adapter. Screwdriver VHF 300 O Ohm Flat Wire 300 to 75 Ohm Adapter 2. Connect the 300 to 75 ohm adapter to the 75 ohm antenna terminal on the treadmill. (See assembly drawing 11 on page 9 for the location of the terminal.) VHF Rod Antenna 300 to 75 Ohm Adapter 75 Ohm Terminal 2. Push the end of the 300 ohm to 75 ohm adapter into the 75 ohm antenna terminal on the treadmill. (See assembly drawing 11 on page 9 for the location of the terminal.) • 75 Ohm Coaxial Cable Refer to the drawing in the lower left corner of this page. Connect the 75 ohm coaxial cable directly to the 75 ohm antenna terminal. (See assembly drawing 11 on page 9 for the location of the terminal.) • . iCATVpABLE,CONNE 1. Remove the VHF 300 to 75 ohm adapter or the VHF cable from the antenna terminal. 2. Connect the CATV cable (75 ohm coaxial cable) to the 75 ohm antenna terminal on the treadmill. (See assembly drawing 11 on page 9 for the location of the terminal.) • 75 Ohm CATV Cable 1!I • VHF 75 Ohm Jack Outdoor Antenna Outdoor antennas are subject to weathering that can reduce signal quality. Inspect the antenna and lead-in wiring before connecting the antenna. Any service center can explain the various outdoor antennas available. Combination VHF/UHF Antennas Read the important precautions on pages 3 to 5 of this manual. Before oper- ating the TV, make sure that the on/off switch lo- cated near the power cord is in the "on" position, and that the power cord is properly plugged in (see "On" page 10). 300 Ohm Flat Wire 300 to75 Ohm Adapter 75 Ohm Terminal on Treadmill 75 Ohm Coaxial Cable 75 Ohm CATV Cable • 300 Ohm Flat Wire 1. Refer to the drawing above. Connect the 300 ohm flat wire to the 300 ohm to 75 ohm adapter. 18 Battery Installation Before the remote control can be operated, two "AAA" Remote Control batteries (included) must be installed. Slide the battery cover off the back of the remote con- trol. Press two bat- teries into the re- mote control. Make sure that the batteries are turned "AAA" Batteries as shown. Reattach the battery cover. Battery Cover