Image Fitness Access 3000 English Manual - Page 19

Turning on the Power To turn on the TV, press the POWER button on the TV or the remote control. Volume Control To adjust the volume to the desired level, press the VOLUME + or - button. The sound level will be shown by a bar on the TV screen. As the sound level is increased, the bar will move to the right. As the sound level is decreased, the bar will move to the left. VOLUME uuU Note: If no broadcasting signal is received, the sound will be muted and the vol- ume control will be disabled. Direct Channel Selection (by Remote Control) Use the channel selection buttons on the remote con- trol to select a channel • number. The channel num- 4 ber will appear on the upper • right corner of the TV screen. For channels 2 through 9, press the 0 but- • ton and then press the desired channel number (if the n0 NUN 0 button is not pressed first, 1V/AV TIMER MENU channel selection will be delayed for 3 seconds). For channels 10 through 99, press the two digits in order. Be sure to press the sec- ond digit within 3 seconds after pressing the first. For CATV channels over 100, press the 1-- button first and then press the desired channel numbers. Sklp Mode Press the CHANNEL A or V button to select memorized channels, skipping over empty channels. Hold down the CHANNEL A or V button to change channels continuously. Note: If no channels are memorized, the TV will switch to the SEARCH mode. Search Mode Press the CHANNEL A or V button to search for the next available channel. Hold down the CHANNEL A or V button to search through all available channels. CHANNEL PROGRAMMING Memorizing Channels The TV is equipped with a channel memorizing function that allows you to step up or down from the current channel to the next channel set into memory. Before channels can be selected in this way, they must be set into the TV's memory. Note: When programming channels, if no buttons are pressed for four seconds, the TV will return to the normal screen. Automatic Memory Tuning 1. Press the MENU button to turn on the pop up menu in the TV mode or CATV mode. Press the MENU button again to select CH MEMORY (channel memory). D CH MEMORY ANALOG CLOCK/TIMER 2. Press the MENU button again to select AUTO MEMORY. >AUTO MEMORY SEARCH/SKIP MEMORY ADD *ERASE TV/CATV 3. Press the + button to start AUTO MEMORY. The TV will begin setting into TV 07 memory all the channels available in your area. When no broadcast signal is detected on a channel, AUTO MEMORY START [+] the channel is erased from memory. When a signal is detected, the channel is stored in memory and the next channel is selected. This process will be repeated until the highest channel is reached. It then stops at the lowest channel stored in memory, and returns to a normal screen after four seconds. The TV will then be in the SKIP mode. TV 07 AUTO MEMORY END Note: Before selecting channels with the CHANNEL A or V button, the channels must be set into the TV's memory. See MEMORIZING CHANNELS at the right. 19