Insignia NS-DV111080F User Manual (English) - Page 12

NS-DV111080F Insignia 1080p Digital Camcorder Setting up your camcorder Charging the battery You can charge the battery with the included battery charger. You should fully charge the battery before using your camcorder for the first time. Note The battery cannot be charged by connecting your camcorder to a computer using the supplied USB cable. To charge the battery: 1 Insert the Li-ion battery into the charging bay. Make sure that you insert the battery with the label facing up, so that the positive and negative terminals on the battery align with the positive and negative terminals on the battery charger. Installing the battery Note The battery cannot be charged by connecting your camcorder to a computer using the supplied USB cable. To insert the battery: 1 Slide the battery latch to open the battery compartment cover. 2 Connect one end of the power cord to the charging unit, then plug the other end into a power outlet. The red LED will light while the battery is charging. When charging is complete, the LED will turn green. It takes about five hours to fully charge the battery. Actual charging time depends on current battery capacity and charging conditions. 2 Insert the battery into the battery compartment. Make sure that the + and - symbols on the battery line up with the + and - symbols on your camcorder. Inserting or removing an SD/SDHC memory card Your camcorder has 128 MB of internal memory. Approximately 70 MB of the internal memory is available for video and photo recording. Because this will allow you to record less than one minute of high definition video or several photos, we recommend using a memory card for video and photo recording at all times. To insert or remove an SD/SDHC memory card: 1 Make sure that your camcorder is turned off. 2 Insert the card into the memory card slot with the arrow on the card pointing toward the slot and the label facing up. 8 www.insigniaproducts.com