Insignia NS-FDRG80W3 User Manual - Page 27

Step 4: Connect the water supply, hose not included. Make sure that the Y-connector is snug by hand

Get Insignia NS-FDRG80W3 PDF manuals and user guides View all Insignia NS-FDRG80W3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

INSTALLATION INSTRUCTIONS 8 Cu. Ft. Electric and Gas Dryers 2 Connect one end of the exhaust ducting to the venting hole on the back of your dryer, then use aluminum tape to secure the ducting to your dryer. The crimped ends of the duct sections must point away from your dryer. Use a 4 in. (10.2 cm) diameter rigid metal duct. Exhaust ducting Back venting hole 3 Connect the other end of the ducting to the exhaust hood, then tighten the duct strap to secure it in place. Tape all joints, including at the dryer. Exhaust hood Step 4: Connect the water supply The water supply lets you use your dryer's steam function. t Tip: Wrap plumber's tape (not included) around threaded connections to prevent leaks. 1 Connect the Y-connector directly to the cold water supply or to an extension hose (not included). Make sure that the Y-connector is snug by hand, then tighten another 2/3 turn with pliers. Cold water Extension hose (optional/not included) Y-connector www.insigniaproducts.com 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
27
www.insigniaproducts.com
8 Cu. Ft. Electric and Gas Dryers
INSTALLATION INSTRUCTIONS
2
Connect one end of the exhaust ducting to the venting hole on the back of
your dryer, then use aluminum tape to secure the ducting to your dryer. The
crimped ends of the duct sections must point away from your dryer. Use a 4 in.
(10.2 cm) diameter rigid metal duct.
3
Connect the other end of the ducting to the exhaust hood, then tighten the
duct strap to secure it in place. Tape all joints, including at the dryer.
Step 4: Connect the water supply
The water supply lets you use your dryer’s steam function.
t
1
Connect the Y-connector directly to the cold water supply or to an extension
hose (not included). Make sure that the Y-connector is snug by hand, then
tighten another 2/3 turn with pliers.
Tip:
Wrap plumber’s tape (not included) around threaded connections to
prevent leaks.
Exhaust ducting
Back venting hole
Exhaust hood
Cold water
Extension hose (optional/not included)
Y-connector