Insignia NS-FDRG80W3 User Manual - Page 46

Cleaning and inspecting the exhaust system, Certain internal parts are intentionally not grounded

Get Insignia NS-FDRG80W3 PDF manuals and user guides View all Insignia NS-FDRG80W3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

NS-FDRG80W3/NS-FDRE80W3 Cleaning and inspecting the exhaust system Inspect and clean the exhaust yearly to maintain optimum performance. 1 Disconnect the exhaust duct from your dryer and from the exhaust hood (at the exhaust outlet) outside of the building. 2 Check the interior of the duct and remove any lint. 3 Make sure that lint is removed from the exhaust hood. Lint may collect in the exhaust hood so that the flappers or louvers will not open or close completely. 4 After cleaning the exhaust hood, make sure that the flapper or louvers move freely. 5 Reassemble the exhaust duct and hood, making sure that the joints are secure and sealed. 6 Operate your dryer and make sure that the exhaust air is not obstructed in the vent and that there are no leaks in the system. Note: Check and clean the outside exhaust hood frequently to ensure a proper air flow. WARNING Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing. Service Personal: Do not contact the following parts while the appliance is energized: Control Board and Temperature-Regulating Thermistor (located on the Blower Housing). 46 www.insigniaproducts.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
46
NS-FDRG80W3/NS-FDRE80W3
www.insigniaproducts.com
Cleaning and inspecting the exhaust system
Inspect and clean the exhaust yearly to maintain optimum performance.
1
Disconnect the exhaust duct from your dryer and from the exhaust hood (at
the exhaust outlet) outside of the building.
2
Check the interior of the duct and remove any lint.
3
Make sure that lint is removed from the exhaust hood. Lint may collect in the
exhaust hood so that the flappers or louvers will not open or close completely.
4
After cleaning the exhaust hood, make sure that the flapper or louvers move
freely.
5
Reassemble the exhaust duct and hood, making sure that the joints are secure
and sealed.
6
Operate your dryer and make sure that the exhaust air is not obstructed in the
vent and that there are no leaks in the system.
Note:
Check and clean the outside exhaust hood frequently to ensure a proper
air flow.
WARNING
Certain internal parts are intentionally not grounded and
may present a risk of electric shock only during servicing.
Service Personal: Do not contact the following parts while
the appliance is energized: Control Board and
Temperature-Regulating Thermistor (located on the Blower
Housing).