Insignia NS-FDRG80W3 User Manual - Page 31
Four-wire outlet - for electric dryers
View all Insignia NS-FDRG80W3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
INSTALLATION INSTRUCTIONS 8 Cu. Ft. Electric and Gas Dryers 3 Connect the other wires to the outer terminal block screws. Be sure to cross the screw through the terminal ring and tighten the screw. 4 Tighten the strain relief screws. 5 Insert the tab of the terminal block cover into your dryer's rear panel slot, then secure the cover with a screw. WARNING: If your are converting from a four-wire electrical system to a three-wire, you must reconnect the ground strap to the terminal block support to ground the dryer frame to the neutral conductor. Ring-type terminals are recommended. If using strap terminals, make sure that they are tightened. Four-wire outlet - for electric dryers: Center terminal block screw Black wire External ground connector Green or bare copper wire of the power cord Neutral grounding wire (white) Red wire Neutral wire (white or center wire) 3/4" (1.9 cm) UL-listed strain relief 1 Remove the center terminal block screw. 2 Connect the ground wire (green or unwrapped) of the power cord to the external ground conductor screw. 3 Connect the neutral wire (white wire) of the power cord and the appliance ground wire (white) under the center screw of the terminal block. Be sure to cross the screw through the ring of the power cord terminal and tighten the screw. 4 Connect the other wires to the outer terminal block screws. Be sure to cross the screw through the terminal ring and tighten the screw. 5 Tighten the strain relief screws. www.insigniaproducts.com 31