Intel P4000S Service Guide - Page 36
Removing and Installing 4x3.5'' Hot-swap Hard Drive, Cage Assembly
View all Intel P4000S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Hardware Installations and Upgrades Removing and Installing 4x3.5'' Hot-swap Hard Drive Cage Assembly NOTE This procedure applies only to the Intel® Server Chassis P4000S family with 4x3.5'' hot-swap hard disk drive cage configuration. Removing 4x3.5'' Hot-swap Hard Drive Cage with Backplane 1. Observe the safety and ESD precautions at the beginning of this book. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the chassis cover. For instructions, see "Removing the Chassis Cover". 4. Remove the front bezel if it is installed. For instructions, see "Removing the Front Bezel". 5. Disconnect the power and data cables to the backplane. 6. Use screwdriver to release the hot-swap hard drive cage (see letter A) from the chassis and remove the hot-swap hard drive cage (see letter B). Figure 32. Removing the 4x3.5'' HDD Cage 7. Lift the EMI shield (see letter A) and move EMI shield outward from the chassis (see letter B). 24 Intel® Server Chassis P4000S Service Guide