Intel SR1550ALSAS User Guide - Page 70
Installing and Removing the Intel, Remote, Management Module and the Intel, RMM NIC
![]() |
View all Intel SR1550ALSAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Installing and Removing the Intel® Remote Management Module and the Intel® RMM NIC Installing the Intel® RMM and Intel® RMM NIC 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information". 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the server system cover. For instructions, see "Removing the Chassis Cover". 4. Remove the PCI riser assembly. For instructions, see "Removing the PCI Riser Assembly". 5. Squeeze the sides of the Intel® RMM NIC module cover to disengage it from the server system back panel and remove it. See letter "A" in the figure below. 6. Remove the paper backing from the self-adhesive foam gasket and attach the gasket to the underside of the Intel® RMM NIC module as shown. See letter "B" in the figure below. 7. Attach the standoffs to the server board (see letter "C" in the figure below) and attach the Intel® RMM NIC module to the server board (see letter "D" in the figure below). 8. Insert the standoff into the hole labeled TH4 on the Intel® RMM board (see letter "E" in the figure below). The standoff installs on the bottom side of the Intel® RMM board. 9. Attach the Intel® RMM board to the server board connector and snap the standoff into the matching hole on the server board. E B D F C A AF000747 Figure 43. Installing the Intel® RMM and the Intel® RMM NIC Module to the Server System 50 Intel® Server System SR1550AL/SR1550ALSAS User's Guide
![](/manual_guide/products/intel-sr1550al-user-guide-13ca15c/70.png)