Intermec CN51 Intermec Terminal Emulator (ITE) User Guide - Page 101
Restarting the Auto-Login, Creating a Custom Parameter File, Upgrading from Config.dat Configuration
View all Intermec CN51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Chapter 3 - Customizing Your Configuration Restarting the Auto-Login Restarts the auto-login script file from the correct HostName statement in the script file when a host session is broken. For this command to work, the WaitFor string must match the last data sent from the host. For example, if the WaitFor string is the login prompt "login:" with a space after the colon, the WaitFor string must include a space for the auto-login restart to work. To use the Auto-Login Restart command, press the keys listed in Appendix B, "Using the Computer Keypad." If Code 39 Full ASCII is enabled on the computer, you can also scan the following bar code: Auto-Login Restart */EALRS* *%ALRS* Note: Code 39 Full ASCII is disabled by default. Use Intermec Settings to enable this feature. Creating a Custom Parameter File At startup, ITE uses parameter settings found in the te_settings.ini file. These parameter settings become the default (cold start) configuration for the computer. You can customize this setup file to preset almost any parameter you can set from the ITE configuration menus. Note: Currently, Intermec does not support the imager via the "Barcode Parms" section described in Chapter 3. There are also some limitations to the laser implementation. If the next message (or similar) appears when you access ITE on your Intermec computer, tap OK to close the message. ITE Image Scanner Barcode Parms menu options NOT supported! Upgrading from Config.dat Configuration Note that the settings from the config.dat file are the same as the settings for the te_settings.ini file. For example, the config.dat setting: [Host A].Host appears as: session_1|host_a|host = 136.179.84.76 in the te_settings.ini file. All values follow the [iccu values] section and use the pipe character to separate the names. The settings and literals are the same as the old config.dat with the exception of the use of the different naming convention using the pipe ("|"). Below are a few values from the config.dat file as they appear in the te_settings.ini file. Intermec Terminal Emulator (ITE) User Guide 89