Intermec IP2L IP2L Snap-On LF/UHF RFID Reader User Guide - Page 36

Chapter 2 - Create RFID Applications and Configure the IP2L RFID Module Settings Descriptions (continued) Setting No Tag Report Report Timeout Timeout Mode ID Tries Antenna Tries Read Tries Description Enables or disables a NOTAG message, which is sent when no tags are found during execution of a Read, Write, or Lock command. Default is disabled. This setting is equivalent to the NOTAGRPT BRI attribute. Sets the timeout (in ms) for delays in tag reporting when the RFID reader is in continuous read mode. Valid range is 0 to 65534. Default is 0. This setting is equivalent to the RPTTIMEOUT BRI attribute. Establishes whether to use the Timeout or Tries attributes. Default is off. This setting is equivalent to the TIMEOUTMODE BRI attribute. Sets the maximum number of times the reader executes the identify algorithm before a response is returned to a Read or Write command. Valid range is 1 to 254. Default is 1. In practice, this is the number of times a tag ID attempt is made for the antenna. This setting is equivalent to the IDTRIES BRI attribute. Sets the number of times the antenna is used for a Read and Write command. Valid range is 1 to 254. Default is 1. This setting is equivalent to the ANTTRIES BRI attribute. Sets the maximum number of times the read algorithm is executed before a response is returned to a Read command. Valid range is 1 to 254. Default is 3. In practice, this is the number of times an identified tag is read until the Read is successful. This setting is equivalent to the RDTRIES BRI attribute. 28 IP2L Snap-On LF/UHF RFID Reader User Guide