Invacare BAR600IVC Owners Manual - Page 34

8 PACKAGING, HANDLING AND SET-UP Installing/Removing Bed Ends ƽ WARNING DO NOT place your hand between the head section and the bed end while assembling. Otherwise, injury may occur.  Reverse this procedure to remove the bed ends. 1. Stand one bed end as close to the head section as possible. 2. With one hand, grasp the head section and raise it until the corner plate head rivets of the section are high enough to place into the corner locks on the bed end. 3. Tilt the bed end toward the head section and place the corner plate head rivets into the corner locks. 4. Return the bed end to its full upright position. The corner plate head rivets will lock into place. 5. Repeat STEPS 1-4 to install the remaining bed end to the foot spring section. 6. If necessary, install the casters. Refer to Installing Casters on page 35. Bed End Rivets Corner Plate Head Rivets Corner Plate Head Rivets Rivets Bed End Head Section Corner Locks FIGURE 5 Installing/Removing Bed Ends Foot Section Corner Locks Invacare®IVC™Model BAR600IVC Bariatric Bed 34 Part No 1123842