Invacare M91 Owners Manual - Page 45

SECTION 9-FRONT RIGGINGS SECTION 9-FRONT RIGGINGS ƽ WARNING After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result. DO NOT stand on the front riggings, otherwise damage may occur. When getting in or out of the wheelchair, make sure that the footplates on the front riggings are in the upward position or moved out of the way. While the wheelchair is moving, minimum ground clearance for the front rigging is three inches. If the wheelchair is not moving, the front rigging MUST maintain a minimum of one inch ground clearance - otherwise personal injury and damage may result. Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position. Installing/Removing Front Riggings CAUTION If front riggings are used, then the seat MUST be adjusted to the highest mounting position - otherwise damage may occur. PW93, PH904A and PHAL4A NOTE: For this procedure, refer to FIGURE 9.1. 1. If necessary, remove the footboard. Refer to Removing/Installing the Footboard Assembly on page 42. 2. Turn front rigging to the side (open footplate is perpendicular to wheelchair) and position mounting holes in the front rigging hinge plates with hinge pins on the wheelchair frame. 3. Install the front rigging hinge plates onto the hinge pins on the wheelchair frame. Hinge Pins Telescoping Front Rigging Support Front Rigging Release Lever Front Rigging Hinge Plate FIGURE 9.1 Installing/Removing Front Riggings - PW93, PH904A and PHAL4A 4. Push the front rigging towards the inside of the wheelchair until it locks into place. NOTE: The footplate will be on the inside of the wheelchair when locked in place. 5. Repeat STEPS 1‐4 for opposite side of wheelchair. 6. To Remove the footrests, push the front rigging release lever inward and rotate the footrest out. Part No 1141450 45 Pronto® M91™ with SureStep®