JVC GR-DVF31 Instruction Manual - Page 29

PLAY PLAYBACK PLAYBACK Basic Playback Power Zoom Lever (VOL.) Power lamp OFF M A Speaker Power Switch Rewind Button Fast-Forward Button Play/Pause Button Stop Button EN29 1 Load a tape (੬ pg. 9). 2 Set the Power Switch to " press 4/6. ". To start playback, •To stop playback, press 5. •Press 2 to rewind, or 3 to fast-forward the tape during Stop mode. To Control The Speaker Volume . . . .... slide the Power Zoom Lever (VOL.) towards "+" to turn up the volume, or towards "-" to turn down the volume. Still Playback: Pauses during playback. 1) Press 4/6 during playback. 2) To resume normal playback, press 4/6 again. ● If still playback continues for more than about 3 minutes, the camcorder's Stop mode is automatically engaged. After 5 minutes in the Stop mode, the camcorder's power is automatically turned off. ● When 4/6 is pressed, the image may not pause immediately while the camcorder stabilizes the still image. During this time, if PAUSE (6) on the remote control is pressed, Slow-Motion Playback will start. This is not a malfunction. Shuttle Search: Allows high-speed search in either direction. 1) Press 3 for forward or 2 for reverse search during playback. 2) To resume normal playback, press 4/6. ● During playback, press and hold 2 or 3. The search continues as long as you hold the button. Once you release it, normal playback resumes. ● A slight mosaic effect appears on screen during Shuttle Search. This is not a malfunction. Slow-Motion Playback, Frame-By-Frame Playback, Playback Zoom and Playback Special Effects Available only with the RM-V711U remote control (provided) (੬ pg. 40, 41). NOTES: ● If Stop mode continues for 5 minutes when power is supplied from a battery, the camcorder shuts off automatically. To turn on again, set the Power Switch to "OFF", then to " ". ● The playback picture can be viewed in the LCD monitor, viewfinder or on a connected TV (੬ pg. 32, 33). ● You can also view the playback picture on the LCD monitor with it flipped over and retracted. ● LCD monitor/viewfinder indications: •When power is supplied from a battery: the " " battery pack remaining power indicator is displayed. When power is supplied through the DC cord: " " does not appear. •During Stop mode, none of the indications are displayed. ● Copyguarded tapes cannot be played back. Only a blue screen is displayed.