JVC KD-SHX850 Instructions - Page 30
To adjust fader and balance, Fad/Bal, To adjust reproduced frequency, level-Crossover
UPC - 046838017278
View all JVC KD-SHX850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
ENGLISH To adjust fader and balance -Fad/Bal Adjust the fader*-speaker output balance between the front and rear speakers. * When crossover network is activated, speaker output balance between high-range and midrange speakers is adjusted. • F12: Upmost-front only • R12: Downmost-rear only Adjust the balance-speaker output balance between the left and right speakers. • L12: Leftmost-left only • R12: Rightmost-right only Select "ON" or "OFF." • If you connect high-range speakers to Front or Rear output, select "ON" for the corresponding HPF; otherwise, the speakers may be damaged. • ON / OFF ON: Activates the filter. \ Press to adjust reproduced frequency level and slope (see below). OFF: Deactivates the filter. \ Press . "Filter Off OK?" appears, then press again. To select the cutoff frequency To adjust reproduced frequency level-Crossover • This setting is available only when crossover network (see page 28) is activated. To activate the filters (HPF/LPF) Select an appropriate cutoff frequency level according to speakers. • 1.6 kHz to 16 kHz: For Front HPF and Rear LPF • 31.5 Hz to 200 Hz: For Rear HPF Select an item. To adjust the slope • Front HPF / Rear LPF / Rear HPF • For Front HPF and Rear HPF: Frequencies lower than the selected level are cut off. • For Rear LPF: Frequencies higher than the selected level are cut off. Front HPF: Rear LPF: Rear HPF: Adjusts HPF for front speakers. Adjusts LPF for rear speakers. Adjusts HPF for rear speakers. Adjust the slope-continuity of sound among speakers. • -18 / -12 / -6 (dB) • As the number becomes higher, the reproduced band width shared among speakers becomes wider. 30