JVC TM-1011GU Instruction Manual - Page 14
How to Use the External Control, How to Use the MAKE/TRIGGER Terminal
View all JVC TM-1011GU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
How to Use the External Control 7About the External Control The Monitor has the MAKE/TRIGGER terminal, which allows you to control the monitor by the MAKE (make contact) or TRIG. (trigger) system selected in the function setting. MAKE (make contact) system: Controls the function by short-circuiting the corresponding pin terminal to the GND pin terminal, or disconnecting (opening) it. TRIG. (trigger) system: Controls the function by inputting the pulse signal instantaneously to the corresponding pin terminal. * Select "MAKE" or "TRIG." from "REMOTE SYSTEM" in SET-UP MENU. ☞ "REMOTE SYSTEM" on page 12 NOTES: • The external control has priority over operations using front panel buttons or menu functions of the monitor. • When using the make contact system, you cannot use the functions which are applied to the MAKE/TRIGGER terminal operating the front panel buttons or the menu of the monitor. (When using the trigger system you can also use those functions operating the monitor directly.) 7How to Use the MAKE/TRIGGER Terminal 7 Function of the MAKE/TRIGGER terminal The following are the configurations and the functions of the pin terminals of the RJ-45 connector. You can change the functions applied to the 1st to 6th pin terminals by setting "REMOTE SYSTEM" of SET-UP MENU. Caution: This is a female connector. NO. 1 INP. A 2 INP. B 3 CO. OFF 4 ASPECT 5 TALLY 6 STATUS 7 8 Functions to be controlled Changes the input to INPUT A Changes the input to INPUT B Turns on/off COLOR OFF Changes ASPECT Controls the tally lamp Turns on/off the status display External control GND 7 To change the functions applied to the pin terminals 1. Display SET-UP MENU, then move the MENU/ VOLUME control to / to select "REMOTE SYSTEM," then move it to . 2. Move the MENU/VOLUME control to / to select "CONTROL FORM," then move it to / to select "SET." 3. Move the MENU/VOLUME control to / to select the number of the pin terminal (PORT F1 - PORT F6) you want to set, then move it to / to select the function. NOTE: • You cannot apply two or more functions to one terminal. 14