JVC TM-1650SDU TM-1650SDU monitor instruction manual (358KB) - Page 11

Set-up menu items H. POSITION V. POSITION WHITE BALANCE DRIVE R.DRIVE B.DRIVE CUT OFF R. CUT OFF G. CUT OFF B. CUT OFF CONTROL LOCK STATUS DISPLAY INPUT REMOTE ASPECT REMOTE Purpose Adjusts the horizontal position of the screen (+ : Horizontal position shifts to the right/-: Horizontal position shifts to the left) Adjusts the vertical position on the screen (+: Vertical position moves down/-: Vertical position moves up) Adjusts the white balance Adjusts red level Adjusts blue level Adjusts red cut off Adjusts green cut off Adjusts blue cut off Sets the operation buttons on the front panel to control lock mode Sets the status display of the color system Sets external control of input selection (INPUT A/B) Sets external control of the aspect ratio Settings -05 -04 01 00 +01 04 +05 -05 -04 01 00 +01 04 +05 Selects DRIVE (DRV) or CUT OFF (CUTO) adjustment. Screen setting is changed to the selected setting mode. Select R/G/B buttons corresponding to the function display to adjust. -20 -19 01 00 +01 19 +20 -20 -19 01 00 +01 19 +20 -20 -19 01 00 +01 19 +20 -20 -19 01 00 +01 19 +20 -20 -19 01 00 +01 19 +20 OFF ON ON OFF OFF A/B OFF ON 4. To set the other set-up menu items, repeat the procedures 2 and 3. 5. Press the MENU button to quit. Front panel Function button displayed Contents MENU MENU EXIT Quit (or Release) the screen Notes: ● When the CONTROL LOCK function is set to ON, pressing operation buttons on the front panel will display the message "CONTROL LOCK ON!" on the screen for about 3 seconds. ● The CONTROL LOCK function is maintained even when the power is turned off. ● To turn off the CONTROL LOCK function, while holding the MENU button press the PHASE button. Then set the CONTROL LOCK function to OFF. ● Even when the CONTROL LOCK function is set to ON, the following operations are available: - Power Switch operation - Volume control with the VOLUME/ SELECT buttons - External control when INPUT REMOTE or ASPECT REMOTE is valid - Display or disappear of the screen. ● The STATUS DISPLAY function can be set to display (ON) or not display (OFF) the present color system when the power is turned on or the input signal is changed. Refer to page 7 for more information. ● When the INPUT REMOTE function is valid (A/B), pressing the Input A, Input B or Input RGB/COMPO./SDI buttons will display the message "REMOTE ON!" on the screen for about 3 seconds. ● The INPUT REMOTE function is valid (A/B) after quitting the screen. 11