JVC TM-1650SDU TM-1650SDU monitor instruction manual (358KB) - Page 7

HOW TO HANDLE BASIC OPERATIONS BASIC OPERATION 1. Press the POWER switch to turn on the power. POWER ON STAND BY ON : Power turns ON. (Power indicator: lit) STAND BY : Power is set to STAND BY. (Power indicator: unlit) 2. Press the INPUT SELECT button to choose input. Select video/audio signals input to terminals on the rear panel. The selected INPUT SELECT indicator lights in green. RGB/COMPO./ SDI B Y/ C VIDEO INPUT SELECT A VIDEO INPUT SELECT button 1 Input A (VIDEO) Terminals on the rear panel Video signal input Audio signal input VIDEO A terminal AUDIO A terminal 2 Input B (VIDEO) 3 Input B (Y/C) VIDEO B terminal VIDEO B (Y/C) terminal AUDIO B terminal 4 Input RGB/ RGB/COMPO. terminal COMPO./ (RGB/Y, B-Y, R-Y) SDI SDI terminal AUDIO RGB/COMPO./SDI terminal * RGB, COMPONENT or SDI signals can be selected in the screen. 3. Press the VOLUME/SELECT button to adjust the speaker volume. - + VOLUME/SELECT Press this button to display the speaker volume level on the screen. + : The Built-in speaker volume is increased. (00 = 50) - : The Built-in speaker volume is decreased. (50 = 00) * Screen indication will disappear about 10 seconds after operating. PICTURE ADJUSTMENT 1. Press select button corresponding to the item you want to adjust. PHASE CHROMA BRIGHT CONTRAST The item you select is displayed on the screen. 1 PHASE ( ) : Phase control 2 CHROMA ( ) : Chroma control 3 BRIGHT ( ) : Brightness control 4 CONTRAST ( ) : Contrast control 2. Adjust with the VOLUME/SELECT button. - + VOLUME/SELECT Items PHASE (Phase) CHROMA (Chroma) BRIGHT (Brightness) CONTRAST (Contrast) VOLUME/SELECT button - + reddish greenish lighter deeper darker brighter lower higher * Screen indication will disappear about 10 seconds after operating. - - STATUS indication (PAL or NTSC) PAL About the STATUS indication ● With the COLOR SYSTEM setting set to AUTO mode, when you turn on the power or select inputs, the color system indication appears for about 3 seconds on the screen while PAL or NTSC signals are being detected. It does not appear when receiving a B/W signal or when no signal is input. Refer to page 8 for more information about COLOR SYSTEM setting and page 10 for more information about STATUS indication setting. 00 ~ 50 VOLUME : 20 + -40 ~ +40 PHASE : 00 + Notes: ● Phase control is effective only in the NTSC color system mode. ● Chroma control is not effective when receiving B/W or when no signal is input. (Except when a component signal is input.) ● When CHROMA is adjusted to "- 40," the picture becomes less colorful. ● "NO EFFECT" is displayed (for about 3 seconds) when your selected function has no effect. 7