JVC TM-1650SDU TM-1650SDU monitor instruction manual (358KB) - Page 6

CONTROLS AND FEATURES (cont'd) REAR VIEW A IN IN VIDEO B IN OUT Y/G RGB / COMPO. RGB SYNC A IN AUDIO B IN RGB / COMPO. IN / SDI REMOTE INPUT A/B OUT 20 OUT 21 Y/C 22 B-Y /B 23 R-Y /R OUT 24 OUT 25 OUT 26 ASPECT 27 A IN IN VIDEO B IN OUT Y/G RGB / COMPO. RGB SYNC A IN AUDIO B IN RGB / COMPO. IN / SDI REMOTE INPUT A/B OUT OUT Y/C B-Y /B R-Y /R OUT OUT OUT ASPECT To AC outlet (120 V AC, 50 Hz/60 Hz) 29 28 SDI IN 30 25 Audio B terminals [AUDIO B IN/OUT] Input (IN) and output (OUT) terminals for the audio signals corresponding to the VIDEO B terminals q or VIDEO B (Y/C) terminals w. The output terminal is bridge- connected. IN : Audio signal input terminal OUT : Bridge-connected audio signal output terminal Notes: * For corresponding video signals, use the VIDEO B terminals q or VIDEO B (Y/C) terminals w. * Also refer to BASIC CONNECTION EXAMPLE on page 13. 26 Audio RGB/COMPO./SDI terminals [AUDIO RGB/COMPO./SDI IN/OUT] Input (IN) and output (OUT) terminals for the audio signals corresponding to the RGB/COMPO. terminals e or SDI terminals p. The output terminal is bridge-connected. IN : Audio signal input terminal OUT : Bridge-connected audio signal output terminal Notes: ● For corresponding video signals, use the RGB/COMPO. terminals e or SDI terminals p. ● Also refer to BASIC CONNECTION EXAMPLE on pages 14 and 15. 27 Remote terminals [REMOTE INPUT A/B, ASPECT] Remote terminals for external control. Selecting INPUT A or INPUT B and the ASPECT RATIO is available via external control. External control is set in the screen. To use external control, you must build a switch cable and connect it to the REMOTE terminals. External control functions ASPECT RATIO INPUT A/B External control switch Open circuit (open) Closed circuit (short) 4-3 (4:3) 16-9 (16:9) INPUT A INPUT B Note: ● Also refer to BASIC CONNECTION EXAMPLE on pages 13 - 15. 28 AC Inlet [AC IN] Power input connector. Connect the provided AC power cord o to an AC outlet (120 V AC, 50 Hz/60 Hz). 29 Power cord Connects the provided power cord (120 V AC, 50 Hz/ 60 Hz) to the AC IN connector. 30 SDI terminals Input (IN) terminal for component serial digital signals and active through output (OUT) terminal. Notes: ● For corresponding audio signals, use the RGB/ COMPO./SDI terminals y. ● Also refer to BASIC CONNECTION EXAMPLE on page 15. 6