JVC TMH-150CGU Instruction Manual - Page 11
Basic Menu Operations (MENU, SET-UP MENU
![]() |
UPC - 046838010682
View all JVC TMH-150CGU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Basic Menu Operations (MENU, SET-UP MENU) 7 About the Menu Screens This monitor features MENU which contains the functions normally used and SET-UP MENU which contains the initial settings of the monitor. MENU Items APERTURE ADJ. BAR POSI. COLOR TEMP. COLOR SYSTEM COMPO. LEVEL1) RUSH DELAY Functions Adjusts the picture aperture level. Selects the level bar position on the screen which appears when adjusting picture or volume. Selects the color temperature. Selects the color system. Adjusts the component level of the monitor for the component signal or the SDI signal. Sets the delay time between when the stand-by button is pressed and when the monitor actually turns on. 1) Appears only when the component signal input or the SDI signal input is selected (when INPUT C or INPUT D is selected and other signals than RGB is input). SET-UP MENU Items PICTURE SUB ADJ. H. POSITION V. POSITION WHITE BALANCE CONTROL LOCK STATUS DISPLAY REMOTE SYSTEM INPUT REMOTE3) Functions The standard value ("00") of the picture adjustment is initially set at the factory. You can adjust the standard value as your initial setting. CONTRAST: Adjusts contrast. BRIGHT: Adjusts brightness. CHROMA2): Adjusts color density. PHASE2): Adjusts hue. Adjusts the horizontal position of the screen. Adjusts the vertical position of the screen. Adjusts the white balance. R. CUTOFF: Adjusts the cut-off point of the red signal. G. CUTOFF: Adjusts the cut-off point of the green signal. B. CUTOFF: Adjusts the cut-off point of the blue signal. R. DRIVE: Adjusts the drive level of the red signal. B. DRIVE: Adjusts the drive level of the blue signal. Prohibits the monitor operations except turning on/off the monitor and adjusting volume. The menu operations are also prohibited. Selects to display or not to display the color system of the current input on the screen. Selects the method of the external control connected to the REMOTE terminal. Sets how to change the input when operating the monitor by the external control. 2) May not appear depending on the type of input signal. 3) Appears only when "REMOTE SYSTEM" is set to "MAKE." 10
![](/manual_guide/products/jvc-tmh150cgu-instruction-manual-db9084e/11.png)