JVC TMH-150CGU Instruction Manual - Page 8

ENGLISH Input Card (option) 7 Component/RGB Input Card (IF-C01COMG) 1 Component/RGB signal input/output terminals Input (IN) and output (OUT) terminals for the component (color G/Y difference) or the RGB signal. IN OUT B/PB/B-Y IN OUT R/PR/R-Y IN OUT HD/CS 1 2 To select Component signal: Press the INPUT SELECT C button. To select RGB signal: Press the INPUT SELECT D button. • The IN and OUT terminals are bridge-connected (auto termination). 2 Connection terminal Attach to the connection terminal of the input card slot on the monitor. IN OUT VD IN OUT AUDIO IN OUT 3 4 3 Synchronized signal input/output terminals Input (IN) and output (OUT) terminals for the vertical, horizontal or complex synchronized signals. • The IN and OUT terminals are bridge-connected (auto termination). NOTE: These terminals are available only to the RGB input. 7 Acceptable signal formats when installed on this monitor: 525/60i, 625/50i 4 Audio signal input/output terminals Input (IN) and output (OUT) terminals for the analog audio signals. • The IN and OUT terminals are bridge-connected. • G on SYNC cannot be used with the RGB input. NOTE: You cannot connect both the component signal outputs and the RGB signal outputs at a time. 7 SDI Input Card (IF-C01SDG) SWITCHED OUT IN SDI 1 IN SDI 2 AUDIO 1 IN OUT AUDIO 2 1 2 3 4 1 SWITCHED OUT terminal Output (OUT) terminal for the re-clocked signal. The input signal from the input terminal currently selected (SDI 1 or SDI 2) is re-clocked and output from this terminal. NOTES: • No signal is output from the SWITCHED OUT terminal when the main power is turned off. • Even when the input signal is switched from the SDI Input Card, the SWITCHED OUT terminal still outputs the SDI 1 or SDI 2 re-clocked signal which is selected last time. The re-clocked signal from SDI 1 is output from the SWITCHED OUT terminal when the monitor is in stand-by mode. 2 D1 SDI signal input terminal (SDI 1, SDI 2) Accepts the SMPTE259M D1 SDI signal. The audio signal of the EMBEDDED AUDIO signal cannot be decoded (only the video signal can be decoded). To select SDI 1: Press the INPUT SELECT C button. To select SDI 2: Press the INPUT SELECT D button. 7 Acceptable signal formats when installed on this monitor: 525/60i, 625/50i 3 Connection terminal Attach to the connection terminal of the input card slot on the monitor. 4 Audio signal input/output terminals (for both SDI 1 and SDI 2) Input (IN) and output (OUT) terminals for the analog audio signals. • The IN and OUT terminals are bridge-connected. 7