JVC XV-S502SL Instruction Manual - Page 15

Basic operations The initial setup before using the unit English We recommend you to set the display language, TV monitor type and digital output before using the unit, depending on circumstances, by following the procedure below. See "Changing the initial settings" on and after page 47 for details about each setting item. T Basic operations ENTER CHOICE OPEN/ CLOSE TV DVD STANDBY/ON TV DVD TV1 TV2 TV3 1 2 3 TV4 TV5 TV6 4 5 6 TV7 TV8 TV9 7 8 9 TV-/-10 TV0 MUTING 0 +10 TITLE/ TV/VIDEO RETURN SUBTITLE GROUP CANCEL OP MENU C+H VOL- ENTER MENU VOL+ CHOICE CH - PREVIOUS ON SCREEN NEXT CLEAR SELECT STROBE SLOW- SLOW+ REPEAT SUBTITLE AUDIO VFP DIGEST ANGLE PROGRESSSIVE SCAN ZOOM 3D PHONIC AMP VOL RM-SXV008J REMOTE CONTROL 5/∞ 1 Press CHOICE for a few seconds to bring up the first page of the DVD PLAYER SET UP display. The pull-down menu of the "ON SCREEN LANGUAGE" is already open. DVD PLAYER SET UP MENU LANGUAGE AUDIO LANGUAGE SUBTITLE ON SCREEN LANGUAGE ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH SPANISH FRENCH SELECT ENTER USE 5∞23 TO SELECT, USE ENTER TO CONFIRM TO EXET, PRESS CHOICE. ON SCREEN LANGUAGE selection 2 Use 5/∞ to select a desired language. You can select the on-screen language for the preference displays, etc. from among English, Spanish and French. 3 Press ENTER. The second page is shown, in which the pull-down menu of the "MONITOR TYPE" is already open. DVD PLAYER SET UP MONITOR TYPE PROGRESSIVE MODE SCREEN SAVER MP3/JPEG 4:3 L.B. 16:9 NORMAL 1AU6T:9O AUTO 4O:N3 LB 4M:P33PS SELECT ENTER USE 5∞23 TO SELECT, USE ENTER TO CONFIRM TO EXET, PRESS CHOICE. MONITOR TYPE selection 4 Use 5/∞ to select a desired monitor type. You can select the monitor type according to your TV. • For the normal (conventional) TV, select "4:3 LB" or "4:3 PS". • For the wide-screen TV, select "16:9 AUTO" or "16:9 NORMAL". See page 49 for details about each mode. 5 Press ENTER. The third (final) page is shown, in which the pulldown menu of the "DIGITAL AUDIO OUTPUT" is already open. DVD PLAYER SET UP DIGITAL AUDIO OUTPUT ANALOG DOWN MIX D RANGE COMPRESSION DOLBY DIGITAL/PCM PCM ONLY DDOOLLBBYYPDRIOGLIOTGAILC/PCM SOTNREAM/PCM SELECT ENTER USE 5∞23 TO SELECT, USE ENTER TO CONFIRM TO EXET, PRESS CHOICE. DIGITAL AUDIO OUTPUT selection 6 Use 5/∞ to select a desired digital output signal type. You must set this item correctly when you connect the unit to an external surround decoder or D/A convertor (including an amplifier/receiver with built-in surround decoder or D/A convertor). (If you do not connect the unit to such a device, you do not have to set this item.) • When connecting with a Dolby Digital decoder, select "DOLBY DIGITAL/PCM". • When connecting with a DTS or MPEG Multichannel decoder, select "STREAM/PCM". • When connecting with other digital device, select "PCM ONLY". See page 50 for details. 7 Press ENTER. The TV screen returns to show the opening display. NOTES • This setting may not be necessary except when turning on the power after purchasing the unit. • You can also set these items, as well as other preferences, by pressing CHOICE briefly to bring up the preference display. See "Changing the initial settings" on and after page 47 for details. 13