Kenmore 4689 Installation Instructions - Page 3
avoid, breakage, Do NOT handle - slide range
View all Kenmore 4689 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
To avoid breakage: Do NOT handle or manipulate the unit by the cooktop glass. The counter-top around the cut-out should be flat and leveled (see hatched area on illustration 1). Before installing the unit, measure the heights of the two (2) cabinet sides (H1-4), front and back (see illustration 1) from the floor to the top of the counter. Level the range using the four (4)leveling legs so that the height from the floor to the underside of the cooktop glass frame is greater than the tallest cabinet measurement Shave Raised 1 1/2"Max. (3.8cm Max.) Edge to Clear Space for 311/2" (81cm) Wide Cooktop. by at least 1/16" (see illustration 2). Illustration 1 Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center of the cabinet cut-out. Remove the protective channels on each side of the glass cooktop (if provided). The metal flange under each side of the cooktop MUST be placed over the cabinet countertop for proper unit support. The glass cooktop should NOT directly touch the countertop (see illustration 2) or could cause glass breakage voiding the warranty. Level the unit if needed. After the installation, MAKE SUREthat the uni is supported by the leveling legs NOT by the cooktop. .-Tosuccessfully install range, the initial level height from floor to underside of cooktop glass frame should be at least 1/16" taller than cabinet sides as measured in step 1. Illustration 2 3