Kenmore 5736 Use and Care Guide - Page 15

Remember • Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained. • Do not store anything on top of the ice maker or in the ice storage bin. REFRIGERATOR FEATURES Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word "Accessory." Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please call the toll-free number on the back cover or in the "Accessories" section. important information to know about glass shelves and covers: Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. For your protection, tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use special care when removing them to avoid impact from dropping. Your model may have glass or wire shelves. Store similar foods together and adjust the shelves to fit different heights. This reduces the time the refrigerator door is open and saves energy. Shelves and Shelf Frames (Fixed and Slide-out} To Remove and Replace a Shelf: 1. Pull the shelf forward to the stop. Tilt the front of the shelf up. Lift to remove from the shelf supports. 2. Replace the shelf/frame by aligning the shelf with the shelf supports. Slide the shelf onto the shelf supports. Be sure that the shelf is securely in position. 2. Replace the dell bin by sliding it back past the stop and pushing into place. Crisper and Convertible Vegetable Meat Drawers To Remove and Replace Drawers: 1. Slide crisper or meat drawer straight out to the stop. Lift the front of drawer with one hand while supporting the bottom of drawer with other hand and slide the drawer out the rest of the way. 2. Replace the crisper or meat drawer by sliding it back in fully past the drawer stop. Crisper or Vegetable/Meat Drawer Covers F To Remove and Replace Covers: 1. Remove the crisper and meat drawers. Press up in center of crisper glass insert until it rises above the plastic frame. Holding the crisper glass firmly, carefully slide the glass insert forward to remove. 2. Lift crisper cover frame and remove. Repeat steps to remove the meat drawer cover. 3. Replace back of meat drawer cover frame into supports or slides on side walls of the refrigerator and lower or slide the front of the cover frame into place. 4. Slide rear of glass insert into cover frame and lower front into place. Repeat steps to replace the crisper cover. (o/"_so'e "_