Kenmore 7800 Use and Care Guide - Page 19

TROUBLESHOOTING Trythe solutions suggested here first in order to avoid the cost of an unnecessary service call. Nothing wilt operate Surface burner makes popping noises ls the burner wet? Let it dry Electrical Shock Hazard Plug into a grounded 3 prong outlet,, Do not remove ground prong_ Do not use an adapter. Do not use an extension cord,, Failure to follow these instructions fire, or electrical shock. can result in death, [] Is the power supply cord unplugged? Ptug into a grounded 3 prong outlet,, [] Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker, If the problem continues, call an electrician,. [] Is the main or regulator gas shutoff valve in the off position? See |nstaliation Instructions, [] Is the range properly connected to the gas supply?. Contact a trained repair specialist or see Installation Instructions., Surface burners will not operate [] is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines., [] Is the control knob set correctly? Push in knob before turning to a setting,, Are the burner ports clogged? See "Sealed Surface Burners" section_, Surface burner flames are uneven, yellow and/or noisy [] Are the burner ports clogged? See "Sealed Surface Burners" section., [] Are the burner caps positioned properly? See Sealed Surface Burners section, [] Is propane gas being used? The range may have been converted improperly. Contact a service technician or see back cove_, Excessive heat around cookware on cooktop Is the cookware the proper size? Use cookware about the same size as the surface area, element or surface burne_, Cookware should more than V_° (t.3 cm) outside the cooking area_, cooking not extend Cooktop cooking results not what expected a Is the proper cookware being used? See "Cookware" section, [] Is the control knob set to the proper heat level? See "Cooktop Controls" section [] Is the range level? Level the range, See the Installation Instructions,, Oven will not operate [] Is this the first time the oven has been used? Turn on any one of the surface burner knobs to release air from the gas lines, [] is the electronic oven control set correctly? See "Electronic Oven Controls" section, [] On some models, is the Control Lock set? See "Control Panef and Oven Door Lock" section, i i":i:.!!:,i Oven burner flames are yellow or noisy [] Is propane gas being used? The range may have been converted improperly. Contact a service technician or see back cove_ Cooling fan runs during baking, broiling or cleaning [] It is normal for the fan to automatically run while the oven is in use and for some time after to coo! the electronic control Oventemperat_Jretoo high or too low [] Does the oven temperature calibration need adjustment?. See Oven Temperature Control section., Display shows messages [] Is the display showing a flashing time? There has been a power failure. Clear the display See "Display(s)" section, On some models, reset the clock, if needed.. See "C!ock" section. ts the display showing a letter followed by a number?. Depending on your model, press CANCEL to clear the display See "Display(s)" section,, If it reappears, call for service., See back cover 19