Kenwood DRV-A100 Operation Manual - Page 16
ATTACH THE MOUNT TO THE WINDSHIELD & START RECORDING, b locking lever, locking lever, c locking
View all Kenwood DRV-A100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
How to use the Adhesive Mount: i. Loosen the (c) locking ring on the suction mount and pull the (d) mounting bracket out. ii. Next, loosen the (c) locking ring from the adhesive mount, and plug the (d) mounting bracket into the adhesive mount. iii. Clean the installation area on the windshield and peel off the plastic covering. Adhere it to the windshield. Loosen Tigten 2. ATTACH THE MOUNT TO THE WINDSHIELD & START RECORDING Remove the protective plastic film and select a position on the windshield where it won't distract you. Then, put the suction mount in place. Release the (b) locking lever from the mount by pulling down on it. Hold the suction mount in place and press against the window. While holding it in place, pull the (b) locking lever back to lock the mount 13