Kenwood DVT-6300-H Instruction Manual - Page 17

LOCK (Continued) Changing the Password (4-digit code) 1 Select LOCK on the setup menu then press the Cursor right (3) key. 2 Enter the old 4-digit code, then press ENTER key. 3 Select "Change" using the Cursor up/down (5/ ∞) keys. then press ENTER. 4 Enter the new 4-digit code, then press ENTER key. Input it again to verify. 5 Press SETUP key to exit the menu. If you forget Password If you forget your security code you can clear using the following steps: 1 Press SETUP key to display the Setup menu. 2 Input the 6-digit number "210499" and the pass- word is cleared. 3 Enter a new code as described above. Country Code 5.1 Speaker Setup 17 Set Up functions DVR-6300 (EN/K,P,E,X) Select speaker settings, including volume balance and delay time, or test the speaker settings. Speaker settings are only active on the Analog MultiChannel Output. Refer to "Speaker setting".™ Disc Audio Disc Subtitle Disc Menu Rating Country Code TV Aspect Menu Language Progressive Scan 5.1 Speaker Setup Others R R Front L Volume Size Distance Test Return 0 dB Small 1 ft Progressive Scan (for U.S.A. and Canada) Preparations Disc Audio Disc Subtitle Disc Menu Rating Country Code TV Aspect Menu Language Progressive Scan 5.1 Speaker Setup Others Code Set C A Enter the code of the country/area whose standards were used to rate the DVD video disc, based on the list in the reference chapter. Ratings are country-dependent. 1 Select "Country Code" (() on the setup menu, then press the Cursor right (3). 2 Follow step 2 of "Rating" on page 16. 3 Select the first character using the Cursor up/ down (5/∞) keys. 4 Shift the cursor using the Cursor right (3) key. and select the second character using the Cursor up/down (5/∞) keys. 5 Press ENTER to confirm your country code selection. Disc Audio Off Disc Subtitle On Disc Menu Rating Country Code TV Aspect Menu Language Progressive Scan 5.1 Speaker Setup Others Progressive Scan Video provides the highest quality pictures with less flickering. If you are using the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN jacks, but are connecting the DVD Player to a standard (analog) television, set Progressive Scan to Off. If you are using the Component Video jacks for connection to a TV or monitor that is compatible with a progressive scan signal, set Progressive Scan to On. Note Once the setting for progressive scan output is entered, an image will only be visible on a progressive scan compatible TV or monitor. If you set Progressive Scan to On in error, you must reset the unit. 1 Press 7 (stop) key to stop any disc that is playing. 2 Press 7 (stop) key again for more than 5 seconds. The video output will be restored to the standard setting, and a picture will once again be visible on a conventional analog TV or monitor.