Kenwood DVT-6300-H Instruction Manual - Page 43
In case of difficulty
UPC - 019048155719
View all Kenwood DVT-6300-H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
In case of difficulty 43 DVR-6300 (EN/K,P,E,X) What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or service representative. Operation to reset The microprocessor may fall into malfunction (impossibility to operate erroneous display, etc.) when the power cord is unplugged while power is ON or due to an external factor. In this case, switch off the power, wait for several seconds, and then switch the power on again. Remote control unit Symptom Remote control operation is not possible. Cause ÷ Batteries are exhausted. ÷ The remote control is too far away from the system, the controlling angle is deviated or there is an obstacle in between. Remedy ÷ Replace with new batteries. ÷ Operate the unit inside the remote control- lable range. Receiver, speakers Symptom Sound is not produced. Sound is not produced from the left or right speakers. Radio stations cannot be received. Noise interferes. A station has been preset but it cannot be received by pressing the PRESET key. No sound from the surround speakers Cause Remedy ÷ The speaker cords are disconnected. ÷ The MUTE key of remote control unit is switched ON. ÷ The headphone plug is inserted into the jack. ÷ Connect properly referring to "System con- nections". 9 ÷ Switch MUTE OFF. ¢ ÷ Unplug the headphone plug. ¢ ÷ The speaker cords are disconnected. ÷ Connect properly referring to "System con- nections". 9 ÷ The antennas have not been connected. ÷ A proper broadcasting band has not been se- lected. ÷ The frequency of the station to be received is not tuned. ÷ Connect antennas. ÷ Select a band. 0 ∞ ÷ Tune to the frequency of the desired sta- tion. ∞ ÷ Car ignition noise. ÷ Influence of an electric appliance. ÷ A TV set is installed near the system. ÷ Install the outdoor antenna in an apart posi- tion from the road. 0 ÷ Switch the suspected electric appliance OFF. ÷ Install the TV or the system at an increased distance between them. ÷ The frequency of the preset station is not tunable. ÷ The preset memory has been cleared because the power cord has been unplugged for a long period. ÷ Preset stations with tunable frequencies. ÷ Preset stations again. § ÷ The LISTEN mode is STEREO. ÷ Select Surround with the LISTEN MODE key. ¡ Knowledge