Kenwood DVT-6300-H Instruction Manual - Page 3

3 Introduction Unpacking DVR-6300 (EN/K,P,E,X) Unpack the unit carefully and make sure that all the accessories are present. If any accessories are missing, or if the unit is damaged or fails to operate, notify your dealer immediately. If the unit was shipped to you directly, notify your shipper immediately. Kenwood recommends that you retain the original carton and packing materials in case you need to move or ship the unit in the future. Keep this manual handy for future reference. Accessories Please confirm that the following accessories are present. FM indoor antenna (1) (For Europe) (For U.S.A., Canada and Loop antenna (1) Australia) Accessories for speaker part (For DVT-6300 and DVT-7300) Speaker cords (6) Video cord (Yellow)(1) Remote control unit (1) Batteries (R03/AAA) (2) For Front (2) For Center (1) For Rear (2) For Subwoofer (1) Length 4.5 m (177-3/16") 3 m (118-1/8") 8 m (314-15/16") 4.5 m (177-3/16") Cushion (15) (Small : 11 pcs ✕ 1 sheet) (Big : 4 pcs ✕ 1 sheet) Preparations For the U.S.A. CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. In compliance with Federal Regulations, the following are reproductions of labels on, or inside the product relating to laser product safety. KENWOOD CORPORATION 2967-3, ISHIKAWA-CHO, HACHIOJI-SHI, TOKYO, JAPAN KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO DHHS REGULATIONS NO. 21 CFR 1040.10, CHAPTER 1, SUBCHAPTER J. Location: Back Panel For the U.S.A. Note to CATV system installer This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. For Canada NOTICE: This Class B digital apparatus complies with Canadian ICES-003. For the U.S.A. FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - - Reorient or relocate the receiving antenna. - - Increase the separation between the equipment and receiver. - - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - - Consult the dealer or an experienced radio / TV technician for help.