Kenwood KDC-MP632U Instruction Manual - Page 14
Audio Setup, Speaker Setting, Filter*1, 3IIHPR
UPC - 019048167293
View all Kenwood KDC-MP632U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
General features Audio Setup Setting the Sound system, such as Cross over Network. 1 Select the source to adjust Press the [SRC] button. 2 Enter Audio Setup mode Press the [VOL] knob for at least 1 second. 3 Select the Audio Setup item to adjust Press the [VOL] knob. Each time you press the knob, the item to be adjusted alternates between the items shown in the table below. 4 Setup the Audio item Turn the [VOL] knob. Front High Pass IIHPFII Filter*1,3 Rear High Pass Filter*1,3IIHPRII Low Pass Filter*l,2,3 11 LPFII Subwoofer Phase*l,2,3,4 IIPHASII Volume offset IIV-OFFII Loudness IILOUD '! Dual Zone System*l 112Z0N" Through/40*5/60*5/80/1 00/ 120/150/180/220*5 Hz Through/40*5/60*5/80/100/ 120/150/180/220*5 Hz 50*5/60/80/100*5/120/ Through Hz -8-±0 OFF/ON OFF/ON ~ ~ • Volume offset: Sets each source's volume as a difference from the basic volume. • Loudness: Compensates for low and high tones during low volume. • *1 Function of KDC-X590/MP632U. • *2 You can control this item when (page 30) is set to "SWPRE SW". (KDC-MP632U only) • *2 You can control this item when (page 15) is set to "SW ON". • *3 You can control this item when "2Z0N" of (page 14) is set to "OFF". • *4 You can control this item when Low Pass Filter is not set to Through. • *5 KDC-X590 only • Dual Zone System Main source and sub source (Auxiliary input) output Front channel and Rear channel separately. - Set up the channel of sub source by (page 30). - Select Main source by [SRC] button. - Adjust the volume of Front channel by [VOL] knob. - Adjust the volume of Rear channel by (page 12). - The Audio Control has no effect on sub source. • You can use the Dual Zone System with the Auxiliary input sources listed below. - Internal auxiliary input (KDC-MP632U only) - Option CA-C1 AXI CA-C2AX (KDC-X590 only) 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the IISTANDBYII display. 2 Enter Speaker Setting mode Press the [VOL] knob. 3 Select the Speaker type Turn the [VOL] knob. Each time you turn the knob, the setting alternates between the settings shown in the table below. OFF For 5&4in. speaker For 6&6x9 in. speaker For the OEM speaker liSP OFF'! liSP 5/411 liSP 6*9/611 "SP OEM" 4 Exit Speaker Setting mode Press the [VOL] knob. 14 I English