Kenwood KDC-X696 Instruction Manual - Page 22
Bluetooth Setup - bluetooth pairing
View all Kenwood KDC-X696 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Bluetooth Setup Selecting the Bluetooth Device 1 Press to enter Bluetooth mode. 2 Turn the volume knob to select [SETTINGS], then press to enter. 3 Turn the volume knob to select [PAIRING], then press to enter. 4 Turn the volume knob to select [PHONE SELECT] or [AUDIO SELECT], then press to enter. 5 Turn the volume knob to select a Bluetooth device name. 6 Press the volume knob to set up the Bluetooth device device name)": The selected Bluetooth device is busy. ■■"- (device name)": The selected Bluetooth device is on standby. ■■"(blank) (device name)": The Bluetooth device is deselected. ■■If two cell-phones or an audio player have already been selected, deselect one device before selecting a new Bluetooth device. 7 Hold to finish the procedure. ■■To cancel the Bluetooth mode, press . Bluetooth Device Registration Test You can check whether your Bluetooth device can be registered using this unit. 1 Press and hold to enter pairing mode "PAIRING" is displayed. 2 "PLEASE PAIR YOUR PHONE" is displayed. ■■When "(device name)" is displayed, select "[PAIRING]" and press the control knob. ■■When "DEVICE FULL" is displayed, delete a Bluetooth device and retry. 1. Turn the volume knob to select the Bluetooth device, then press and hold to confirm. 2. Turn the volume knob to select "YES", then press to confirm. 3 Start registering this unit by operating the Bluetooth device. By operating the Bluetooth device, register the hands-free unit or audio unit (pairing). Select "KENWOOD BT CD/R-5T1" from the list of found units. 4 Input the PIN code ("0000") in the Bluetooth device. Check that registration is complete on the Bluetooth device. PIN code is set to "0000" as the default. You can change this code. Refer to [PIN CODE EDIT] under (page 23). 5 "(device name)" is displayed. Press and hold the volume knob. "BT TEST" is displayed. 6 The connection result, "OK" or "NG", is displayed. ■■"PAIRING": Registration to this unit ■■"HF CNT": Hands-free phoning ■■"AUD CNT": Audio playback ■■"PB DL": Phone Book downloading 7 Press to exit pairing mode. ■■Data (Phone Book, etc.) of the cell-phone checked for connection does not remain in this unit. Bluetooth Setup 1 Press to enter Bluetooth mode. 2 Turn the volume knob to select [SETTINGS], then press to enter. 3 Turn the volume knob to make a selection, then press to confirm. ■■See table below for selection. ■■Repeat step 3 until the desired item is selected/activated. ■■Press to return to the previous item. 4 Hold to finish the procedure. ■■To cancel the Bluetooth mode, press . 22 English