Kenwood KDC-X696 Instruction Manual - Page 24
Function settings
View all Kenwood KDC-X696 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Function settings 1 Press SRC to select a source other than "STANDBY". 2 Press the volume knob to enter [FUNCTION] mode. 3 Turn the volume knob to select [AUDIO CONTROL] or [SETTINGS], then press to enter. 4 Turn the volume knob to make a selection, then press to confirm. ■■See table below for selection. ■■Repeat step 4 until the desired item is selected/activated. ■■Press to return to the previous item. 5 Hold to finish the procedure. [AUDIO CONTROL] : While listening to any source except in STANDBY state or Bluetooth mode. Item Selectable setting (Preset: *) SUB-W LEVEL -15 - 0 * - +15: Adjusts the subwoofer output level. BASS LEVEL -8 - 0 * - +8: Source tone memory: Adjusts the level to memorize in each source. (Before making an MID LEVEL adjustment, select the source you want to adjust.) TRE LEVEL EQ PRO KDC-X696 only BASS ADJUST BASS CTR FRQ 60/ 80/ 100 */ 200: Selects the center frequency. BASS LEVEL -8 - 0 * - +8: Adjusts the level. BASS Q FACTOR 1.00 */ 1.25/ 1.50/ 2.00: Adjusts the quality factor. BASS EXTEND ON: Turns on the extended bass. ; OFF *: Cancels. MID ADJUST MID CTR FRQ 0.5K/ 1.0K */ 1.5K/ 2.5K: Selects the center frequency. MID LEVEL -8 - 0 * - +8: Adjusts the level. MID Q FACTOR 0.75/ 1.00 */ 1.25: Adjusts the quality factor. TRE ADJUST TRE CTR FRQ 10.0K/ 12.5K */ 15.0K/ 17.5K: Selects the center frequency. TRE LEVEL -8 - 0 * - +8: Adjusts the level. PRESET EQ NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects a preset sound mode suitable to the music genre. (Selects [USER] to use the customized bass, middle, and treble settings.) BASS BOOST B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred bass boost level. ; OFF *: Cancels. LOUDNESS LOUDNESS LV1 */ LOUDNESS LV2: Selects your preferred low and high frequencies boost to produce a well- balanced sound at a low volume level. ; OFF: Cancels. BALANCE L15 - 0 * - R15: Adjusts the left and right speaker output balance. FADER R15 - 0 * - F15: Adjusts the rear and front speaker output balance. SUBWOOFER SET ON *: Turns on the subwoofer output. ; OFF: Cancels. DETAILED SET HPF THROUGH *: All signals are sent to the front speaker. ; 100/ 120/ 150 (HZ): Frequencies lower than the specified value are cut off. LPF THROUGH *: All signals are sent to the subwoofer. ; SUBWOOFER 85/ 120/ 160 (HZ): Frequencies higher than the specified value are cut off. SUB-W PHASE REVERSE (180°)/ NORMAL (0°) *: Selects the phase angle of the subwoofer output to be in line with the speaker output for optimum performance. (Selectable only if a setting other than [THROUGH] is selected for [LPF SUBWOOFER].) 24 English