Kenwood KMM-BT318U Instructional Manual - Page 39
How to remove the unit, Installing the unit in-dash mounting, When installing without the mounting - wiring
View all Kenwood KMM-BT318U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
INSTALLATION/CONNECTION Installing the unit (in-dash mounting) Do the required wiring. ( 36, 37) Hook on the top side Orientate the trim plate as illustrated before fitting. Dashboard of your car Bend the appropriate tabs to hold the mounting sleeve firmly in place. When installing without the mounting sleeve 1 Remove the mounting sleeve and trim plate from the unit. 2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and secure the unit with screws (supplied/commercially available). Use only the specified screws. Using wrong screws might damage the unit. How to remove the unit For 1 Detach the faceplate. 2 Fit the catch pin on the extraction keys into the holes on both sides of the trim plate, then pull it out. 3 Insert the extraction keys deeply into the slots on each side, then follow the arrows as shown on the illustration. For / / Part list for installation (A) Faceplate (B) Trim plate (C) Mounting sleeve (D) Wiring harness (E) Extraction key For For / / (F) Screws (supplied for ) ENGLISH 35